Hollow Copper Rivets for PCB GND on M/W boards 200 pcs

Here are 200 pcs of soft hollow copper rivets that are perfect for providing ground vias through PC boards. Simply drill a hole, pop this through and use a center punch to spread the far side, then sodler both sides.  I have watched the various internet groups talk about how to do this, and finally remembered I had a few thousand of these!  I will add the dimensions in a day or so, I have to remeasure but they are roughly 1/8 inch dia by 3/16 long.  I weighed two hundred pieces then added a few so you get over 200!  Have fun, see my other stuff if you are looking for microwave parts! Remember, I gladly will combine shipping to save you money! Note: I have measured the ID and found that a #47 drill (.078 in.) will easily pass through while a #46 (.081 in) is stopped by the internal lip at the smooth end (opposite the flare). If riveted with the appropriate swage, the ID should accomodate .080.